How to Use the TDS Water Tester for Checking Drinking Water Quality

Step-by-Step Guide:

1. Power On : Turn on your TDS water tester by pressing the power button.
2. Remove Cap : Take off the protective cap from the testing probe.
3. Immerse in Water : Dip the probe into the water you want to test. Make sure the water level is above the minimum immersion line.
4. Stir Gently : Stir the tester gently in the water to remove any air bubbles.
5. Read Results : Wait a few seconds for the reading to stabilize. The TDS level will display on the screen.
6. Compare : Compare the reading to the acceptable TDS levels for drinking water. For reference:
- 0-50 ppm: High purity
- 50-100 ppm: Relatively high purity
- 100-200 ppm: Average purity
- 200-300 ppm: Poor purity
- 300-400 ppm: May form scale
- 400-500 ppm: Poor taste
- >500 ppm: Not recommended for drinking

7. Turn Off : After use, turn off the tester and replace the protective cap.

Why Use It?
- Ensure Safety : Make sure your drinking water is safe and free from excessive impurities.
- Monitor Filter Performance: Check if your water filter is effectively reducing TDS levels.
- Convenient and Quick : Get accurate results in seconds with minimal effort.

Order Your TDS Water Tester Now for Peace of Mind and Clean, Safe Water!

Shop Now

Back to blog

Leave a comment

1 of 3